logo LTS
LTS Company

Contacts

Main office
02125, Kiev, Osvoboditely avenue, 3, office 18
tel. +38 (050) 777 09 90

Equipment for briquetting of sawdust and bio-fuels

Lines for the production of fuel briquettes (NESTRO)

This type of equipment is used for the briquetting of organic waste:

Line Options:

If the raw material has the optimum moisture content and fractional composition of briquetting material (husks, dry sawdust, grain), crushing and drying does not need. The technological process of briquetting (in general) consists of the following steps: collection of raw materials, grinding, storage, sorting, drying and pressing, packaging of briquette , storage and shipping . Briquetting line equipment can be placed parallel or mixed. Serial lining machines and mechanisms should be approximately the same. The lines parallel aggregation equipment performance ratio can be different . Most easiest way to use a serial arrangement of equipment equipped with buffering devices that carry flexible connection between adjacent units. Buffer device for briquetting lines a silo or cyclone with mechanisms for delivering briquetting mass.

Basic requirements for the feed:

 

Briquetting of wood waste.

Chunky wood waste feed to chipping machine to obtain chips and then send to grinding machine for making sawdust. These shavings and sawdust from primary production are sent to the hopper. From the hopper the chips are fed into the heat source of the drying drum and the furnace flue devices. In the heat generator sawdust mixed with the flue gases and send to the drying drum. Drying drum is adjacent to furnace complete with special hopper with dispensing function and between them there is a heat generator. From the drying drum air mixture (saw dust with flue gases) fed into the cycle. Sawdust feed to the cycle by means of pneumatic effect that creates by a fan. The same fan sucks the flue gases from the furnace. Inside the Cyclone it separates the dry sawdust from waste gases. Sawdust deposited on the bottom through the rotary valve (feeder) deliver to conveyor then it delivers to a pressing equipment (if it has hopper) or to the storage. Dry sawdust send to pressing equipment from storage.

 

 

1. Line for briquetting (NESTRO) sawdust, sunflower husks, straw and other wood waste 400 kg per hour (8 hours shift). The next configuration:

Individual equipment

Productivity, kg/h

Number of units

Power consumption, kW/h

Wood Shredder 500 1 11
Deck Hammer Crusher 1000 1 30
Aerodynamic Dryer 400 1 11
Impact mechanical press 400 1 18.5

 

2. The line for briquetting (PINI KAY) sawdust, sunflower husks, straw and other wood waste 400 kg per hour (8 hours shift). The next configuration:

Individual equipment

Productivity, kg/h

Number of units

Power consumption, kW/h

Wood Shredder 500 1 11
Deck Hammer Crusher 1000 1 30
Aerodynamic Dryer 500 1 11
Press Pini&Kay 500 1 45

 

3. The line for granulation of sawdust, sunflower husks, straw and other waste wood 800 kg per hour (8 hours shift). The next configuration:

Individual equipment

Productivity, kg/h

Number of units

Power consumption, kW/h

Wood Shredder 800 1 15
Deck Hammer Crusher 1000 1 30
Aerodynamic Dryer 800 1 15
Granulator 800 1 55